Bridge - Progeny 

Progeny is imaging software.  Website:  www.progenydental.com

To activate the bridge, in the Main Menu, click Setup, Program Links. Double click on Progeny in the list. Check the Enabled box, then verify the Path of file to open is correct.  Click OK. You will now have a button in your Chart module labeled 'Progeny'.

Technical Data
The following patient information is sent to Progeny when the bridge button is pressed in EZ: first name, last name and identifier (either PatientNum or ChartNum depending on the setting 'Enter 0 to use PatientNum, or 1 to use ChartNum').  Patients are loaded in Progeny based on the identifier passed in from OD.  Progeny doesn't accept two word last names.

Troubleshooting
Problem:  Receive an error message in Progeny: No Patient Selected.
If you close Progeny, then launch the bridge in EZ2000 Plus Dental, this error message may display depending on how long Progeny takes to load.  Eventually, the patient does load.
Solution:  To avoid this message, leave Progeny running in the background.

Problem: When I launch the Progeny program link, more than one instance of Progeny is created.
Solution: Call Progeny support to get help upgrading Progeny to version 1.10 or later.